Full set of 10 RaceWax Ninja Studs Stomp Pad Black
- Ten peel and stick Ninja studs in black.
- Each plated aluminum stud measures 25 mm x 25 mm x 5 mm high.
- Provides grip for your foot in the lift area.
- Need a few more? Also get add-on set of 5 (PB-5244).
- Arrange the ten studs in any pattern.
- Won't hide your snowboard graphics.
- Hint: Follow all directions and use some rubbing alcohol to make sure the surface is clean of any oils or grease, allow to dry, then stick them on and stack some books on top for compression to set.
FOR OPTIMUM BONDING:
- 1. Board and stomp should be at room temperature, 70 F [ 21 C ]
- 2. Clean surface with rubbing alcohol. Surface must remain clean, smooth and dry. Do not touch.
- 3. Use a blow dryer on high to heat up the prepared board surface as well as the adhesive on the traction device.
- 4. Immediately after heating, place the stomp and press firmly. Stack some books on top of the stomp without twisting, the more weight the better.
- 5. Allow the adhesive to cure at room temperature for 24 hours.
There are no reviews for this product at this time.Write a Review